P Series Attention: All the images, schemes and photos are property of Coprel s.a.s. and are under Copyright.   Motors - P Series Technical Specifications: single-phase, 2 shaded-poles, impedance protected motor, built complying “CE” standards, with self lubricating and aligning sleeve bearings with big oil reservoir; motor with “F” insulation class ( 155°C); suitable for continuous duty with room temperature between -10°C and + 60°C; electric supply by 6,3x0,8mm male faston-type connectors, directly fixed on coil (see the scheme below); operating voltages between 12V and 400V 50/60Hz; motor stack dimensions 61x61mm; clock-wise version and counterclockwise version; temperate-steel driving shaft d. 4,5 or 6mm.   On Request: motors with different power; protection against dust and/or humidity; coil bobbin with “IP56” protection class; dustproof end-shields with “IP50” protection class; motor with “H” insulation class ( 180°C); electric supply with flying cables of various lengths; double or triple speed motor and/or double voltage; thermal protector or thermal cut off protection; spacers of various lengths and/or protruding screws in order to fix the motor on a wall; version built complying UL-CSA standards; double shield bearings (ZZ); cooling fan wheel; motor stack dimensions 61x64 mm (E series) and motor stack height from 10 to 40 mm with different power; six motor types VDE1306 approved: three of them in “B” class ( 130°C) and three in “H” class ( 180°C); electric supply by 4,8x0,8mm male faston type connectors directly fixed on coil.   ID code:   (*) impregnated versions: IV Version: impregnated coil bobbin through immersion in epoxydic varnish (classic impregnation of stators); PRN Version: coil bobbin spread with black epoxydic resin, the bobbin is protected by a visible layer of resin; IM Version: the coil bobbin is impregnated through immersion in epoxydic varnish with silicon put in the contacts zone at the end of the winding and 3 cores cable, and the bobbin is covered by a nylon cap. The coil bobbin is not submerged in the resin, but well visible, it should be necessary to pay attention and to place the motor in a way that the open part of the cap will be directed downward in order to prevent that it could fill up of humidity; INC Version: coil bobbin in “IP56”, the bobbin is completely submerged in the epoxydic resin. Faston position:  (View from the protruding driving shaft side) Dimensions: fori 2x4MA a richiesta Versions:  Type Motor stack height Voltage Frequency Input power W Input current A A mm. B mm. P 10-1 10 35 230 50 17 0,170 P 15-1 15 40 230 50 14 0,114 P 20-1 20 45 230 50 17,8 0,145 P 25-1 25 50 230 50 28,6 0,259 P 30-1 30 44 230 50 28 0,230 P 35-1 35 60 230 50 37 0,300 P 40-1 40 70 230 50 48 0,355   All motors, fans and blowers are manufactured in our factory in Pieve Emanuele (Milano – Italy). Dimensions and specifications can vary. We reserve ourselves the right to make changes anytime we consider it’s the case.
	©  Copyright 2007 Coprel S.r.l. All brands, product labels and companies are property of their respective owners. Developed by internetlandia