AX/SA Series

The Axial Fans, used especially in the refrigeration sector, are suitable for use when reduced space is required with high air volumes and medium-low pressure.
15 – 54 W
0,12 – 0,40 A
90 – 900 m3/h
AX SA Axial Fans

Technical specifications

  • Single phase, 2-shaded poles, impedance protected motor, built according to the CE mark requirements, in compliance with EN 60335-1 standard, with self-aligning and self lubricating sleeve bearings with big oil reservoir.

  • Motor with minimum 130 “B” insulation class.

  • Suitable for continuous operation in ambient temperature from -10  °C to +50  °C.

  • Electrical connection by 6,3 x 0,8 mm, radial or axial, male faston-type connectors, directly fixed on coil.

  • Fan blade made of nylon reinforced with fibreglass or aluminium.

  • Motor support bracket made of galvanized metal sheet.

On request

  • Version with IMQ – CSV approved motor.

  • Fans blades of various diameters and inclinations.

  • Motor with different powers and insulation classes: 155° “F” – 180° “H”.

  • Protection against dust and/or humidity.

  • Supply voltage from 12V to 400V 50/60 Hz.

  • Double speed and/or dual voltage version.

  • Electrical connection by means of different cable lengths.

  • Motor coil winding with IP55 protection.

  • Thermal protector and/or thermal fuse.

  • End-shields with IP50 protection class.

  • Built in compliance with UL-CSA standards.

  • Version with double shield ball bearings.

  • Without the support bracket.

  • Spacers of various lengths and/or protruding screws for fan wall mounting.

  • Motor cover made of black nylon reinforced with fibreglass.

  • SA type bracket for use with fan blades 200 mm and 230 mm diameter.

Faston position and rotation

Fan blade action

Blowing

The overall dimensions of the motor reduce fan performance

Suction

We recommend the suction version

Product Identification Code

AXAX or SA series
017/BModel
TThermal protection:
T = thermal protector
F = thermal fuse
Blank = impedance protected
1Coil winding code
3Faston position
RElectrical connection:
R = radial faston-type connectors
A = axial faston-type connectors
C = cables
ARotation:
O: clockwise
A: anticlockwise
AAction:
A: suction
P: blowing
IVOn request
HT: high-temperature version
IV - IM = low temperature with high relative humidity up to 92% *
INC = coil insulation with IP55 protection *
230Supply voltage
50Rated frequency

* IV version

Impregnated coil through dip-coating using epoxy transparent paint (standard stator coil dip-coating process).

* IM version

Impregnated coil through dip-coating using transparent epoxy paint with silicone applied on contacts at the end of winding, three-pole wire and coil covered by a nylon cap. The coil is not drowned in the resin but visible; caution should be paid when mounting the motor so that the cap open part faces downward to prevent its filling up with condensate.

* INC version

Coil with IP55 protection, the coil is completely drowned into the epoxy resin.

Dimensions mm

AX

Dimensions mm

SA