P Series

Single-phase 2 shaded poles Motors for various applications.
These motors are extremely cheap and strong, with an irreversible rotation direction; they do not produce radio interference.
14 – 48 W
0,11 – 0,35 A
Single-phase 2 shaded poles Motors

Technical specifications

  • Single phase, 2-shaded poles, impedance protected motor, built according to the CE mark requirements, in compliance with EN 60335-1 standard, with self-aligning and self lubricating sleeve bearings with big oil reservoir.

  • Motor with minimum 130 “B” insulation class.

  • Suitable for continuous operation in ambient temperature from -10  °C to +50  °C.

  • Electrical connection by 6,3 x 0,8 mm, radial or axial, male faston-type connectors, directly fixed on coil.

  • 61 x 61 mm stator lamination.

  • 4,5 mm or 6 mm diameter driving shafts.

On request

  • IMQ – CSV approved version.

  • Supply voltage from 12V to 400V, 50 or 60Hz.

  • Motor with different powers and insulation classes: 155° “F” – 180° “H”.

  • Protection against dust and/or humidity.

  • Electrical connection by means of different cable lengths.

  • Motor coil winding with IP55 protection.

  • End-shields with IP50 protection or with different shapes.

  • Double speed and/or dual voltage version.

  • Thermal protector and/or thermal fuse.

  • Spacers of various lengths and/or protruding screws for motor wall mounting.

  • Built in compliance with UL-CSA standards.

  • Version with double shield ball bearings (ZZ).

  • Cooling fan.

  • 61x 64 mm stator lamination (E series), 10 to 40 mm motor stack height, of different powers.

  • Driving shaft built to customers design.

  • Electrical connection by 4.8 x 0.8 mm, male Faston-type connectors, directly fixed on coil.

  • Stator with cataphoresis coating.

Faston position and rotation

Product Identification Code

PSeries
20Motor stack height:
10 - 15 - 20 - 25 - 30 - 35 - 40
TThermal protection:
T = thermal protector
F = thermal fuse
Blank = impedance protected
1Winding code
3Faston position
RElectrical connection:
R = radial faston-type connectors.
A = axial faston-type connectors.
C = cables
ARotation:
O: clockwise
A: anticlockwise
BBOn request:
BB: ball bearings
IVOn request
HT: high-temperature version
IV - IM = low temperature with high humidity
up to 92% *
INC = coil insulation with IP55 protection *
VROn request: cooling fan
230Supply voltage
50Rated frequency

* IV version

Impregnated coil through dip-coating using epoxy transparent paint (standard stator coil dip-coating process).

* IM version

Impregnated coil through dip-coating using transparent epoxy paint with silicone applied on contacts at the end of winding, three-pole wire and coil covered by a nylon cap. The coil is not drowned in the resin but visible; caution should be paid when mounting the motor so that the cap open part faces downward to prevent its filling up with condensate.

* INC version

Coil with IP55 protection, the coil is completely drowned into the epoxy resin.

Dimensions mm

dim_P